Installation guide for Nikon F-3 (1/2)


->02

1. Remove the original leatherette of the camera, please remove carefully for this leatherette. We are going to recycle brass plate.		2. Use alcohole or solvent or Benzine, dip for a while and remove the brass plate carefully.
3. Rub rubber cement (rubber bond) on the brass plate.
4. Also rub cement on the body.		5. Then stick brass plate on the body.
6. Please stick another plate, too.		7. Strengthen the edge portions (halftone portions of the photo above) with rubber cement (rubber bond). You can get it on the DIY shop.
8. Rub rubber cement on the edge portions		9. Apply the rubber cement thinly with cotton swab and dry it well, 3 to 5 minites or more.
10. Reverse the new covering from the base paper. and you are facing on the adhesion side. Then rub alcohol (or benzine or water) on the halftone portion with cotton swab. Then go to ->02