Pentax LX covering kit quick installation guide.

1. Remove the original covering and clean up the surface very well.		2. The new covering kit comes like this.
3. Reverse the covering and rub alcohol (reccomended) or water with cotton swab on the adhesion side, red halftone portion on the above photo. The alcohol delays adhesion and allows you time to adjust and position the leatherette.
4. Start applying, make sure the iron plate (red allowhead on the above photo) is on the correct place.		5. Set the selftimer.
6. Squeeze the covering under the selftimer lever. Please do it before the alcohol get dry.
7. Use flathead screwdriver and squeese the narrow portion.		8. Then apply the covering until the end.
9. Now you have finished the left-front portion, then go to the next.		10. Start applying the right-front leatherette.
11. Apply the leatherette to the correct place.		12. Squeeze and adjust with the flathead screwdriver.
13. Rub alcohol (reccomended) or water with cotton swab on the adhesion side, green halftone portion on the above photo.
14. Squeese the leatherette on the upper side of the film reminder pocket, please do it before the alcohol get dry.		15. apply the leatherette along the edge.
16. Do not stretch the leatherette, it naturally comes to the end.		17. Finished. wait until the alcohol get dry.